#6.4 hemi coolant temp sensor location driver
#6.4 hemi coolant temp sensor location full

The coolant temperature sensor is located below the intake manifold on the driver side of the cylinder head. Monitor engine temperature and ensure that it is steady below 100 Degrees Celsius or 210 Degrees Fahrenheit.

(Edited) Hello, STAR certified systems technician for MB here.

2014 No i just got it outta shop thursdsy for electrical issue.

#6.4 hemi coolant temp sensor location full

Run Engine with reservoir cap off & the Heater on full for about 30 minutes.ĩ. Mechanic01 20,228 satisfied customers Where is the air fuel ratio sensor located on a Ram 2500 Where is the air fuel ratio sensor located on a Ram 2500 pickup with a 6.4 liter hemi read more Eric 54,559 satisfied customers Motor spuddering.

Let the truck get up to temp which takes a little longer and let the thermostat open. Joined Posts 8,720 Reaction score 14,862 Location. Cover engine parts with rags and place low profile buckets underneath the engine bay to catch the old coolant.ĥ.Add Orange OEM coolant until coolant flows out of water pump plug hole.Ĩ. So iv got the water and coolant set aside. Clear work area for access to water pump plug located at the front of the engine.Ģ. 14-16PSI of pressure is a normal range across the board for many different makes and models of vehicles. Rags and low profile buckets (Tuperware etc. Id be looking for ways to get that 'normal' temp cooler in the Hemi platform by at least 20 degrees. I couldnt hear any fans come on, I guess thats why my truck is still at the. Fuel injectors (located next to each side of the intake manifold) Camshaft position sensor (CMP) (located at the front of the pass side cylinder head) Oil. They only had the one temperature rating.

The 6.4 loves heat for optimal performance. It seems to be a pencil heater to regulate the thermo-stat better for heat. At 235 its at the 3/4 mark on the temp gauge, and 250 is in the red with an audible alarm and 'engine temp hot on evic display. Took the first one apart to see what the wires are on the thermostat housing. The job of an ECT sensor is to monitor and control the rise and fall of the. Hemi Coolant Bleeder Location and Fill Procedure! Typical done when there is air in the coolant system, especially after replacing the radiator, hoses, thermostat, reservoir tank, water pump or anything to do with the coolant system in which the system is unsealed and air is introduced.ġ/4″ Allen Key for Water Pump Plug (Teflon tape optional, the tapered threads should be enough, Teflon Tape added for extra insurance) I know by experience that my gauge stays in the center until over 220 degrees, and then it starts to climb above half. The ECT is located in the coolant passage in your engines cylinder head.